This is a test version of Biostars. For the public version, visit https://www.biostars.org.
RNA variant calling, aligned with HiSat2

Trying to do my variant calling on RNA paired tumour-normal pairs with Mutect2.

Reads were aligned with Hisat2 and alignment is 97-98%.

I ran Mutect 2 and it gave me about 100 SNPs and 100 indels (across the whole exome). I validated these against known variants from previous targeted sequencing on the same subject.

I then went back and did some preprocessing- marking duplicates, splitNCigar and BQSR.

The SNPs are about the same- slightly fewer but probably just increased sensitivity- but I now have 5000 indels.

I have a feeling that SplitNCigar should not be used on Hisat2 aligned reads and this is the reason for these 'indels'.

Has anyone else found similar? Can I variant call using Hisat2 aligned reads, and just skip the SplitNCigar step?

hisat2 gatk splitncigar
• 2,869 views • link
written by OhHiImNewHere • OhHiImNewHere

2 answers

The reason you have 5000 indels is probably because some spliced reads are now (for whatever reason) being considered indels. Since GATK is mainly used for DNA-seq, then it's not really a surprise.

The SplitNCigar step is needed for running BQSR but to what extent this is even helpful for RNA-seq is unclear.

You could be correct in thinking that HISAT2 alignments don't have the right flags/scores to be compatible with GATK's SplitNCigar, to verify this I would suggest re-aligning with STAR (2-pass mode) as suggested in the link from ATpoint. I do recall that bowtie had some issues with GATK so it could be that those also exist in Hisat2.

Either way I would be extremely skeptical of any indels from RNA-seq data... probably safest to focus on SNVs. If you are extremely interested in specific INDELs, I would make sure to go look at them in IGV and verify that they are real before moving forward.

• 0 views • link
written by benformatics benformatics

I far as I understand it, SplitNCigar was designed specifically to make data alignmed with a splice-aware aligner compatible with the GATK pipeline. Its clearly helpful for RNAseq because it takes a spliced read and turns it into two non-spliced reads.

• 0 views • link
written by i.sudbery i.sudbery

Thanks- I think after some discussion that the best thing to do is just focus on SNVs.

• 0 views • link
written by OhHiImNewHere • OhHiImNewHere

As the process of variant calling in RNA-seq is even less standardized as compared to DNA-seq, and given that RNA-seq is inferior than DNA-seq for it, I would at least (and simply) follow the guidelines Broad has put out:

https://gatk.broadinstitute.org/hc/en-us/articles/360035531192-RNAseq-short-variant-discovery-SNPs-Indels-

Not saying it is perfect (in fact I do not know) but at least it is a path to follow and a somewhat citable reference.

• 0 views • link
written by ATpoint ATpoint

Log in to answer this question.

More posts like this