This is a test version of Biostars. For the public version, visit https://www.biostars.org.
Do I need to remove adapter if FastQC showed no adapter content.

I am new to RNA seq analysis.

I ran FastQC and results showed there is no adapter content. But there are still some overrepresented sequences.

Do I still need to remove adapter?

If so, how can I find the adapter?

Thanks a lot!

rna-seq
• 6,748 views • link
updated by GenoMax GenoMax • written by jolin0701-dy jolin0701-dy

1 answer

It does not hurt to pass your reads through a scan/trim program. If there is no adapters present, no changes would be made to the data. You will only expend some time but would be assured that the data is clean.
BBDuk.sh from BBMap, trimmomatic or cutadapt are all paired-end data aware scan/trim programs. You will find sequences of all commonly used adapters in "adapters.fa" file in the "resources" directory of BBMap. Trimmomatic/cutadapt may also provide adapter sequences.
Note: If you do have light adapter contamination (sounds like the case here) then most NGS aligners should be able to take care of it (soft clipping). So if you don't want to scan/trim, you could proceed with alignments.

• 1 views • link
written by GenoMax GenoMax

Thanks a lot!! It is very useful ~~

• 1 views • link
written by jolin0701-dy jolin0701-dy

Agreed. Also as of bcl2fastq 2.17.1.14 adapter trimming can take place while creating the fastq file.

• 2 views • link
written by Ian Ian

Log in to answer this question.

More posts like this