Why does my ATAC trace only have 1 peak while everything is OK?

I strictly abide by the 10x genomics scATAC-seq protocol, and the quality of nuclei is very good. However, my data trace only have 1 peak at 200 bp.

I wonder if the transposon enzyme digested too much.

Thank you for your help!

genomics 10x atac-seq

• 973 views • link

updated 4.6 years ago by ATpoint

• written 4.6 years ago by 631079064 •

What are we talking about? Bioanalyzer/TapeStation, or alignment results?

• 0 views • link

written 4.6 years ago by ATpoint

0 answers

No answers yet.

More posts like this

Confusion Regarding Tape Station Peak
written 2.0 years ago by Bhavya •

Hi I made a transcriptome library. I ran a tape station on it. Expected size of the library was ~300 bp. My peak came around …
Is there a tutorial/ demo on single cell nuclei-seq analysis
written 3.9 years ago by Emily •

Is there a tutorial/demo on single cell nuclei-seq (snRNA-seq or sNuc-seq) downstream analysis? I see lots of scRNA-seq when trying to google it but not …
Extend ChIP-seq peaks to known Restriction Enzyme Digest Sites?
written 6.0 years ago by science_lizard •

I am performing a protocol that is very similar to ChIP-seq, except that it uses restriction enzyme digestion (with a cocktail of 4-5 restriction enzymes) …
Low number of peaks and weird TSS profile
written 6.6 years ago by mickey_95 •

Hi, I am looking at ATAC-seq data of good/decent quality. I used MACS2 for peak calling and was surprised to see los numbers of peaks …
how to merge different peak sparse matrices
written 7.6 years ago by anlau62 •

Hi, I used 10X cellranger atac software to analysis scATAC-seq data, but the software could only analysis one sample per time, and produced separate filtered …
is this insect nucleotide sequence transpon (SINE family)? Need help with transposon.
written 7.7 years ago by lijunmin •

![sequences inserted into insect genome and potential tranposon identified in Repbase][1] [1]: https://i.imgur.com/aPafaAG.png Hello everyone, I've tried to confirm a sequence which is transposon or …
HOMER annotatePeaks.pl problem
written 8.9 years ago by Seq225

I am using HOMER to get read mapping around TE (well, I need to make a heatmap). I am using following command: annotatePeaks.pl XXX.bed XXX(genome) …
What's the difference between Trim galore and Cutadapt when it comes to quality trimming ?
written 9.9 years ago by hxlei613

Hi. Trim galore makes use of cutadapt. Both of them use the algorithm thar is the same as the one used by BWA. However, in …
FastQC of small rna-seq
written 10.6 years ago by marcon •

Hello, Recently I received some small rna-seq data to analyze. Since I have never worked with small rna-seq data I'm a bit lost with fastQC …
Velvet assembly failure at low kmers
written 11.5 years ago by a.alsheikh •

I've signed up to seek help in an assembly problem which I couldn't manage to resolve. Any help is very much appreciated. I'm using Velvet …