FastQC is not recognising that there are adaptors
FastQC is not recognising that there are still adaptors before trimming. Do you think it is because I have merged many files together?
fastqc
• 759 views
•
link
updated
by
jared.andrews07
1.9K
• |
written
by
Miss
0
0 answers
No answers yet.
Log in to answer this question.
More posts like this
-
adaptors removal before using bowtie for bam generation (from fastq)
written by S 0Hello, I would like to run AS analysis using rMATS from 2 reps of human rna-seq data (2 fastq files - single end), I first …
-
Per sequence GC content still not good after trimming
written by zouini6 0I am analyzing NGS data for a prokaryotic genome and FastQC initially failed "Per sequence GC content". I then ran Trimmomatic on my Fastq files …
-
Unusual FastQC Per Base Sequence Content
written by RBright21 1Hi Everyone Is anyone able to assist with the cause of something unusual I have noted on a FastQC output? I have scoured the internet …
-
Nanopore Preprocessing Step
written by santos48 4When I analyze Nanopore reading, should I analyze each file individually(I have over 1000 .fastq files) or combine it with the cat command to analyze …
-
FastQC Illumina Universal Adaptors present
written by williamsbrian5064 55Hi I just received some RNA-Seq data. When I run FastQC on the files, it appears that there are a decent amount of Illuminia universal …
-
Adaptors Sequences and Trimming
written by lzass18 1Hi everyone, I received a lot of good help last time, and I hope someone will be able to help me this time as well. …
-
smallRNA - adaptor trimming stringency
written by ti&te 4Dear all, I am trying to analyze my smallRNA seq data and before alignment it is recommended to trim sequenced reads. What stringency for trimming …
-
Trimming of 16S reads
written by agata88 88Hi all, I was wondering if you can help me to solve one problem. Here I describe the steps of analysis I've performed: 1. Download …
-
FastQC of small rna-seq
written by marcon 1Hello, Recently I received some small rna-seq data to analyze. Since I have never worked with small rna-seq data I'm a bit lost with fastQC …
-
FASTQC can't detect short overrepresented sequences (e.g., less than 25 bp)?
written by Cacau 52I have tried to use FASTQC to detect short overrepresented sequences at the 5' end of my reads. I am sure that there are adaptors …
That shouldn't matter. And by merging "files", I assume you mean concatenating FASTQs from the same sample that was sequenced across lanes?
How do you know there are adaptors? FastQC presumably only checks for the most common adapters, so if you have a less common platform/setup, then perhaps it wouldn't recognize them.